McDATA 1U Server Instrukcja Obsługi Pobierz pdf (Strona 259)

100

101

RRP: Power Supply

5-23

Removal and Replacement Procedures (RRPs)

RRP: Power Supply

Use the following procedures toremove or replace apower supply. A

list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• Standard flat-tip screwdriver.

• ESD grounding cable and wrist strap.

Removal To remove a power supply:

1. If the director is installed in a stand-alone configuration, go to

step 2. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16" door tool into

the socket hole at the right top of the rear door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet rear door as directed by

the customer representative.

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to the

director chassis and wearingan ESD wrist strap.

2. Follow ESD procedures by attaching a wrist strap to the director

chassis and your wrist (Figure 5-1).

3. Identify the defective power supply from the extinguished green

PWR OK LED on the supply or failure information at the

management server Hardware View.

4. Useaflat-tipscrewdrivertoreleasethehandleatthetopofthe

power supply.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 429 430

Komentarze do niniejszej Instrukcji

Brak uwag

McDATA 1U Server Instrukcja Obsługi Strona 259

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery McDATA 1U Server