McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Pobierz pdf (Strona 257)

100

101

CLI Commands

2-213

show

Output The device information is displayed as a table that includes the

following:

Output Example The output from the show.openTrunking.config command appears as

follows:

Unresolved Congestion: Enabled

Backpressure: Disabled

Low BB_Credit Threshold (%): 75 (default)

Port Threshold %

---- ------------

1 60 (default)

2 69

3 60 (default)

4 60 (default)

5 90

680

...

show.openTrunking.rerouteLog

Syntax reroutelog [clear]

Purpose This command displays the Open Trunking Re-route Log

information.

ATTENTION! If the switch is restarted (as occurs during IPL, IML,

configuration reset, feature key installation, or firmware load) or is power

cycled, the information in the Open Trunking Re-route Log is lost.

Unresolved

Congestion

The current enabled/disabled state of the unresolved

congestion trunking feature.

Backpressure The current enabled/disabled state of the

backpressure trunking feature.

Low BB_Credit

Threshold

The current threshold setting of the low BB_Credit

threshold trunking feature listed as a percentage. If

this value is configured to be the default, (default)

is displayed alongside the threshold value. The

default value is 75%.

Congestion

Threshold Table

A table mapping each port number on the switch to a

corresponding threshold setting. The threshold is

listed as a percentage. If this value is configured to be

the default, (default) is displayed alongside the

threshold value. The default value is 60%.

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 405 406

Komentarze do niniejszej Instrukcji

Brak uwag

McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Strona 257

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking McDATA OPENconnectors Command Line Interace