McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Pobierz pdf (Strona 215)

100

101

CLI Commands

2-171

perf

• Alert State: Disabled

Parameters This command has one parameter:

TIP: Although the system supports a name length of 64 characters, you may want to

use a much shorter name. Some commands that display the threshold name show a

maximum of 51 characters. If you specify lengthy names, you can display the complete

name by entering the comma-delimited mode using the commaDelim command. For

more information, see Using the commaDelim Command on page 1-19.

Command Example Root> perf thresholdAlerts throughput addAlert port6Rx

perf.thresholdAlerts.throughput.addPort

Syntax addPort name portNumber

Purpose This command adds a port to the specified throughput threshold

alert.

NOTE: An alert cannot be modified unless it is in the disabled state. Verify

that the alert is disabled before executing this command.

Parameters This command has the following parameters:

name Specifies the name of the new throughput threshold

alert. This name can consist of any ASCII characters

up to a maximum length of 64 characters. To use

spaces or special characters in this name, put

quotation marks around the name. This parameter

is case-sensitive.

name The name of a throughput threshold alert as

defined by the command

perf.thresholdAlerts.throughput.addAlert, described on

2-170.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 405 406

Komentarze do niniejszej Instrukcji

Brak uwag

McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Strona 215

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking McDATA OPENconnectors Command Line Interace