McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Pobierz pdf (Strona 174)

2-130

Enterprise Operating System Command Line Interface User Manual

perf

•Ports: None

• Utilization Type: None

• Utilization Percentage: 50%

• Duration: 30 minutes

• Interval: 60 minutes

• Alert State: Disabled

Parameters This command has the following parameter.

TIP: Although the system supports a name length of 64 characters, you may want to

use a much shorter name. Some commands that display the threshold name show a

maximum of 51 characters. If you specify lengthy names, you can display the complete

name by entering the comma-delimited mode using the commaDelim command. For

more information, see Using the commaDelim Command on page 1-17.

Command Example Root> perf thresholdAlerts throughput addAlert port6Rx

perf.thresholdAlerts.throughput.addPort

Syntax addPort name portNumber

Purpose This command adds a port to the specified throughput threshold

alert.

NOTE: An alert cannot be modified unless it is in the disabled state. Verify

that the alert is disabled before executing this command.

name Specifies the name of the new throughput

threshold alert. This name can consist of any

ASCII characters up to a maximum length of

64 characters. To use spaces or special

characters in this name, put quotation marks

around the name. This parameter is

case-sensitive.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 327 328

Brak uwag

McDATA OPENconnectors Command Line Interace Instrukcja Użytkownika Strona 174